Regardless of bends, twists, or turns, Example of a cut line on LED strip lights

2. You will now have two LED strip lights. Carefully peel back the end portion of the paper strip covering the strip’s adhesive backing, and then remove the 3M VHB adhesive from the solder pads on the bottom side of one of the strips. The strip with its adhesive peeled back will be the top strip when soldered.

5. Align the non-tinned strip segment (strip with adhesive removed) directly over the newly tinned pads, and apply heat. Hold the soldering iron in place until the solder remelts and begins to flow. To strengthen the bond and improve visual appeal, a small portion of solder can be added to the top pad.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split and solder a run of non-weatherproof two-conductor or connecting wires. Peel away the blue wire so that only the positive (red), negative (black), and control (green) wires are left.

*No wires should be peeled away if you’re joining single-color or standard RGB light strips.

3. Properly heat your soldering iron. For best results, clean and tin the tip of the iron immediately before soldering. To tin the iron, touch solder to both sides of the iron’s tip.

4. Next you will need to tin the solder pads on both ends of the split strip light. When soldering, always apply heat to the target area on the strip and not directly to the solder. Once sufficient heat has been applied to the area, start introducing solder.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split, solder, and reseal a

3. Follow steps two through five located at the top of this post for soldering a standard RGB strip light.

4. To reseal the strip light, apply

The LED strip lights are now connected, and power should flow through the entire length of the weatherproof strip.

Hopefully, you have surge protectors set up in your house to protect your electronics from power surges, or voltage spikes, that can fry your devices. Unfortunately, surge protectors won't save you from the evil cousin of a power surge -- a low voltage event, or brownout. Dimming lights in your house are a sign that you're experiencing a brownout, which over time can cause major damage to your appliances. 

Since your air conditioner is one of your most powerful appliances, any brief outage means it takes a lot of electricity to power the unit back up. To combat the problem, Direct Energy and One Hour Air Conditioning & Heating® offer the Comfort Sentry Contactor, a switching device with totally sealed contacts that goes in your AC unit. If voltage goes below a safe point or "flickers," the Contactor will automatically and safely turn the unit off — and then back on once the right amount of power is back. "In multiple dwellings, it will stagger turning power back on, one in 30 seconds, another in 5 minutes, and so on — to avoid using too much electricity all at once. It's protection built right into your home," explains Dave Borowski, spokesperson for Direct Energy. A smart homeowner will recognize this as an "ounce of prevention."

Older houses have a charm and appeal for most homeowners. A hundred years ago, homes weren’t as modular as today’s building techniques but instead trim work, mantles and cabinetry were built according to the space available and the contractor’s ability. Antique carpentry can be a thing of beauty, but electric systems that aren’t up to date can be a nightmare.

Old Outlets

The first problem with older outlets is they don’t typically have the ground plug. Appliances at one time were independently grounded, whereas modern appliances are designed to rely on the external ground for safety. Adapters are available, but they’re really only intended as a quick fix, not long term usage.

Secondly, outlets in an antique house are likely well past their intended operating life. A worn out outlet can be frustrating at best if it only works intermittently, and can be a dangerous fire hazard at worst if it is overheating or causing a spark due to a loose connection. The good news is, outlets themselves are relatively simple and inexpensive to replace.