One of the things that makes electrical troubleshooting so difficult is the fact that your electrical system is largely behind the scenes. Located behind your walls and in your ceiling, many issues will not manifest until they become very serious. As a result, it can be very easy to ignore electrical problems until they come to a point where they can no longer be ignored. To combat this, especially if you live in a n older home, you should have an electrician in Santa Monica inspect your electrical system regularly. By doing so, you can avoid many issues that result from an aging home and electrical system.

In addition to having a regular inspection, you should also educate yourself on the early signs of electrical issues. If you notice any of the below, make sure that you get in touch with a Santa Monica electrician right away. It can save you significant time and money if you take care of the issue early on, rather than when it becomes a real problem.

Lights Dim Unexpectedly

Do you have lights that dim whenever large appliances, such as your air conditioner cycles on? If these high-demand appliances are not on dedicated circuits, then they could be causing electrical issues within your home.

No GFCI Outlets

According to most local building codes, a ground fault circuit interrupter (GFCI) outlet is required in all areas that are frequently wet. This includes kitchens, bathrooms, utility rooms and garages. If you do not have these, call The Electric Connection or click here.

Ungrounded Outlets

Older homes were often equipped with outlets that do not accept three-pronged, grounded plugs. This is a very strong indication that your electrical system is not grounded. If you have an ungrounded electrical system, then you could be exposing yourself to unnecessary dangers every time you use your electrical system. Have someone inspect your system and provide the proper grounding if necessary.

A bit of mathematics at the end of the week. The

The first table shows three different installations. The old one is equipped with T8 fluorescent lamps that are at the end of their lifetime and dirty. That is why the luminous flux is so low for the 60W tube. In this situation, the need for a replacement is present. The choice is between a fluorescent tube, a LED tube or a completely new installation with controls. Controls reduce the average power consumption to 1/3 and less of the original load. We can estimate the new fixtures will consume 12W only when connected to controls that detect presence in the hall and reduce the lighting level in areas that are not in use. Each light point will be replaced. It is (often) possible to reduce the number of fixtures with a new installation. The example is concentrating on a one-by-one replacement to make it easier to understand.

The table above shows the sum of all costs for running and maintaining the installation each year and in total. The Retrofit Solution reaches an ROI after 2 years already. The New Installation with controls is going to turn back the high investment after 10 years. Both LED solutions do better than the conventional one, save energy and CO2 emissions. Let’s go green with LED light sources!

The good news is that heating systems in modern homes are safer than they’ve ever been before. But while many people never experience any major risk to their safety due to a furnace or boiler, it’s still a possibility. Any heating system that uses combustion to work, like a natural gas furnace, could potentially leak a dangerous gas called carbon monoxide (CO, for short) into the home.

The heat exchanger is where combustion produces a flame as natural gas ignites. This heat is contained within a heat exchanger made of aluminum or steel. It is essentially a curved tube, and the smoke and carbon monoxide byproducts vent through the other end and out of the house. Air blows over the heat exchanger to heat up and is sent to the ducts running throughout the home.

Unfortunately, over time, the heat exchanger can become damaged. This is especially true if you have anyone but a professional technician work on your furnace, but it can also happen with time. You should have HVAC technicians inspect your heating system each and every year to check for leaks and cracks.

Carbon monoxide is an odorless, colorless gas. That means you wouldn’t have many ways to notice if it were in your home. It is poisonous, and sometimes people don’t know about it until people in the house start to get sick.

Carbon monoxide detectors save lives. A CO detector near each room where people sleep (and throughout your living spaces) should be tested each month and replaced every 5-10 years. You should also replace the batteries for your CO and smoke alarms every 6 months (even if the test works).