Motion sensor LED stair lights let you safely and effectively navigate your steps while eliminating the need for any action. And because they turn off automatically, they also save power! We’ve recently installed these handy little LED stair lights and wanted to share the process with you.

wire that will be needed. It is best to order more than you need so that there’s slack in the line and enough to extend to where your power supply will be mounted.

It’s important to choose the correct wire gauge for the length of wire you need and amount of current that will be flowing through it. The key is to avoid voltage drop, which happens when the supplied energy of a power source is reduced as electric current flows through wire (or any other pieces of equipment that do not supply voltage on a circuit). The longer the run of wire, the lower the gauge of wire needed.

*If you need help determining the correct wire gauge, don’t hesitate to call us toll free at 866-590-3533. Our customer service and technical support teams are available from 8:30 a.m. to 8 p.m. CDT Monday-Thursday and 8:30 a.m. to 4 p.m. CDT on Friday.

3. Using wiring from the

4. Use a run of wire to join the PIR sensor at the top of your steps with the power supply. You can wire both PIR sensors to the power supply using electrical tape or with

5. Connect your main line to the PIR sensor at the bottom of your steps, and begin connecting each step light with

7. Finally, connect to power.

LED stair lights and

4. Connect your main line to the PIR sensor at the bottom of your steps, and begin connecting each step light with

6. Finally, plug the power supply into your wall outlet.

via Wikimedia

2. Ricky Martin wins Song of the Year

Puerto-Rican heart throb Ricky Martin played a huge role in bringing Latin pop to the American music scene during the 41st Grammy Awards show in February of 1999. In December he was rewarded again at the Billboard Music Awards by winning Song of the Year for his hit single “Livin’ La Vida Loca.”

Regardless of bends, twists, or turns, Example of a cut line on LED strip lights

2. You will now have two LED strip lights. Carefully peel back the end portion of the paper strip covering the strip’s adhesive backing, and then remove the 3M VHB adhesive from the solder pads on the bottom side of one of the strips. The strip with its adhesive peeled back will be the top strip when soldered.

5. Align the non-tinned strip segment (strip with adhesive removed) directly over the newly tinned pads, and apply heat. Hold the soldering iron in place until the solder remelts and begins to flow. To strengthen the bond and improve visual appeal, a small portion of solder can be added to the top pad.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split and solder a run of non-weatherproof two-conductor or connecting wires. Peel away the blue wire so that only the positive (red), negative (black), and control (green) wires are left.

*No wires should be peeled away if you’re joining single-color or standard RGB light strips.

3. Properly heat your soldering iron. For best results, clean and tin the tip of the iron immediately before soldering. To tin the iron, touch solder to both sides of the iron’s tip.

4. Next you will need to tin the solder pads on both ends of the split strip light. When soldering, always apply heat to the target area on the strip and not directly to the solder. Once sufficient heat has been applied to the area, start introducing solder.

The LED strip lights are now connected, and power should flow through the entire length of the strip.

The following steps demonstrate how to split, solder, and reseal a

3. Follow steps two through five located at the top of this post for soldering a standard RGB strip light.

4. To reseal the strip light, apply

The LED strip lights are now connected, and power should flow through the entire length of the weatherproof strip.