Technology is transforming our lives. It seems like each day there is a better way to live our lives with technology. As a homeowner with an older home, you may think that incorporating some of these technological advances in your home is cost-prohibitive, but it’s not. The following are a few ways you can make your home smart, without it costing you and arm and a leg.

If you own an electric car, or you are considering getting Tesla’s new Model 3, we can help you install sockets that will allow you to charge your car faster since traditional outlets may take a little longer.

Take a few minutes to look for and correct electrical hazards in your home. It does not take too long to check the insulation on a table lamp cord, check for the correct wattage light bulbs and install a GFCI (Ground Fault Circuit Interrupter). Take the time. It will prevent an electrical safety hazard and save you and your loved ones lives.

Unsafe conditions such as overloaded circuits and damaged insulation as well as the misuse of extension cords and electrical devices create fire hazards and may result in serious electrical injury.

Studies of residential electrical fires show that the majority of serious fires could have easily been avoided. The conditions that caused the fires probably would have been detected by an electrical inspection. These problems were not detected or corrected because no inspections had been made for several years. In a number of cases homes ranging from 30 to 100 years old had not been inspected since they were built. A safety inspection should be performed by a qualified licensed electrician.

One good tip to determine when your electrical system was last inspected is to examine the door and cover of your electrical panel. The panel should contain a label or tag with a date, a signature, or initials on it. If there is more than one date, the most recent one should be the date of the last inspection. DO NOT remove the service-panel cover. This is a job for a qualified electrician. If the date is older than ten years, its time for a inspection and correction of any problems that show.

Call us for help at 808-647-0599

We’ve recently added a new explosion-proof light for use in granaries, paint booths, mills, mines, oil refineries, auto shops, marine vessels, shipyards, and other hazardous locations.

This LED light is listed as UL1598 for wet locations and UL1598A for outdoor marine applications. It is classified as UL844 and meets National Electric Code—NFPA 70, article 500—requirements in the U.S. for Class 1 Division 1 (groups C and D), Class 1 Division 2 (groups A, B, C, and D), and Class 2 Division 2 (groups F and G) hazardous locations. The light fixture meets IECEx Zone 1, 2, 21, and 22 requirements for safe operation around combustible gas and dust.

Designed to replace 320-watt metal-halide (MH) fixtures with comparable output—the 100-watt LED explosion-proof light emits 13,000 lumens of natural white illumination. This weatherproof LED fixture operates within a 100-277V AC range and is built to last five times longer than MH lights.

The durably constructed light has a vibration-resistant anodized aluminum housing that prevents the release of sparks from internal components. The die cast housing is also powder coated for corrosion resistance and has a removable back plate for access to the constant-current driver, which is sealed with a silicone gasket. LEDs are protected by a tempered glass lens.

A conduit is required for installation, and the fixture has two openings for input and output connections. The LED explosion-proof light can be pole mounted or mounted to a wall, floor, or ceiling with its included bracket. A five-year warranty protects against any manufacturer defects or malfunctions.