Outlets are wired into your home to make it convenient to plug in anything from an appliance to a lamp. However, an electrical fault can occur endangering your home. It’s not a good idea to have 19 different appliances plugged into a single outlet. This can cause a short; not to mention the maze of cords running through the room aren’t safe for family and pets.

Sometimes electrical faults in your system can cause a ceiling light or fan to stop working. After identifying that a bad bulb is not the culprit, you should turn off the power and inspect the light fixture itself. Check the cable and flex connections and make sure the terminal screws are tight. Use a continuity tester to make sure the flex hasn’t gone bad requiring a replacement.

Lights, fans, and other fixtures can also stop working because a residual current device has tripped. You can reset the device but if it trips again it’s best to call in a certified electrician.

If you are still experiencing problems after doing these simple troubleshooting tasks, it’s always best to call in a trained electrician. Outlets or lights that are malfunctioning could be caused by exposed wires somewhere in your electrical system. If your circuit breaker continually trips, it means the current in your home is not cycling as it’s intended. Either way, it’s much safer to have these issues repaired by a good electrician.

LED fixtures, such as

With energy consumption that is less than half of what 150-watt LED parking lot light that is a direct replacement for 400-watt metal-halide (MH) fixtures. That’s 250 watts less for the same amount of light!

The average price of electricity per kilowatt-hour (kWh) is 12 cents. To figure out the monthly cost of running 25 LED parking lot lights for 11 hours per day, use this formula: (combined wattage x monthly hours of use)/1,000 x price per kWh. For 25 LED lights, (3,750 x 330)/1,000 x .12) the total would be $148.50 per month or $1,782 per year.

When the same formula is used for 400-watt MH fixtures, the monthly cost is $396, and yearly cost would be $4,752. So, in this situation, switching to LED fixtures would save approximately $3,000 per year. When coupled with the savings on maintenance, LED fixtures can save $6,470 per year. At that rate, the cost of 25 $340 LED fixtures would be recouped within two years.

Left: LED wall packs; Right: HID wall packs

Unlike LED fixtures that light up instantly, HID parking lot lights require a warmup period of up to 10 minutes before they reach full brightness. They also can’t be turned immediately back on after being switched off; this is called restrike time, and it can take up to 15 minutes before they can be turned on again. Attempting to power on the lights before the bulbs have cooled can damage a fixture’s components and cause the HID bulb to fail sooner.

HID lamps consist of a ballast and a quartz tube that contains gas, metal salts, and two tungsten electrodes. In order to create light, an electric arc passes from one electrode to the other through a gas (most commonly mercury, metal halide, or sodium). The mercury used in this process is dangerous if enough is inhaled or released into the environment. If an HID bulb bursts, all contents should be put into a sealed container or sealed bag and taken to a recycling center or hazardous waste facility. If HID fixtures are used indoors, wall packs and canopy lights, are used indoors, the possibility of ultraviolet (UV) radiation exposure should be taken into consideration. HID bulbs emit a substantial amount of UV radiation, but an outer glass envelope prevents the radiation from escaping. However—according to the FDA—”If the outer bulb breaks and the inner tube continues to operate unshielded, intense UV radiation is emitted. UV exposure at this level can cause eye and skin burns, as well as blurred or double vision, headaches, and nausea.” The UV light from an HID bulb with a broken envelope can also lead to discoloration of items and fabric. LEDs emit little to no UV radiation.

In short, LED lights are a better alternative to HID parking lot lights. They offer a great deal in the way of savings, longevity, maintenance reduction, brightness, color, and safety. While it may take a short amount of time to recoup the price of switching to LEDs, all of their qualities make it easy to see why so many businesses have started the process.

For technical questions, don’t hesitate to call us toll free at 866-590-3533. Our customer service and technical support teams are available from 8:30 a.m. to 8 p.m. CDT Monday-Thursday and 8:30 a.m. to 4 p.m. CDT on Friday.

As a rule, the bottom of any hanging light should be at least 6’8″ off the ground – unless it’s over a table or island. When you have an 8′ ceiling, this doesn’t give you a whole lot of room to play. If you long for the grand impact of a decorative

A room with a single light fixture is depressing. Kick the shadows by adding multiple light sources. A few stylish flush-mount ceiling lights. Some table lamps. An accent light here or there. When you have multiple lights shining in different directions, the space will feel lighter and more open. Make sure to place ceiling lights at least 3′ from the wall, any closer and harsh shadows will make your ceiling seem lower.