From the 1950s to the 1980s, the Federal Pacific Electrical Company (FPE) installed electrical panels in millions of homes across the country. Unfortunately, these electrical panels are basically recipes for disaster—over the years, electricians and home inspectors have found that FPE panels often fail to protect homes from overcurrent or short circuits. The danger seems to happen randomly: even if panels have been installed and working properly for years, a single incident can quickly cause the panel to overheat and create a major fire hazard.

Remember—circuit panels trip in response to unusual surges of electricity. If they fail to trip, as FPE panels often do, those electrical surges cannot be stopped or shut off manually and will move through your home until they run out of fuel or until the wires burn out. This could cause the panel to overheat and catch fire, leading to a potentially serious disaster.

FPE panels may not be up to modern safety codes – electrical safety standards have been updated significantly since the 1980s, and experts say that FPE panels, which were produced from the 50s and into the 80s, do not meet these updated standards. Some of the deficiencies noted by home inspectors include:

FPE panels may have serious design flaws – not only do FPE panels not meet modern safety standards, but they also came with some serious design flaws that weren’t even common among panels built around the same time. Some of the most significant flaws include:

FPE panels may have manufacturing defects – as if that weren’t enough, the Consumer Product Safety Commission (CPSC) has noted a number of defects that make FPE panels unfit for homes, including weak materials used to construct the breakers that may prevent them from tripping and could cause the panel to catch fire.

If you live in an older home and you’re worried your panel might be a danger, call Kolb Electric. Our trained electricians are familiar with the potential hazards of FPE and other outdated panels and can replace your existing panel with a modern panel that will keep your home safe for decades.

For more information about circuit panel replacement in Maryland, Virginia, or Washington, DC, call Kolb Electric today.

House wiring has undergone some dramatic changes in the last hundred years. What was once a relative luxury is now accessible (and even required) in just about everyone home in the country. That isn’t to say that all wiring is created and maintained equally, nor can we confidently say that any Des Moines home is safe for your family without giving it an on-site look.

If you’ve ever done a renovation or addition to your home, you know the nightmare that city and county building codes can be. It seems like someone at the city and county clerk’s office is sitting around all day dreaming up new ways to make your progress come to a screeching halt. While your home may not have been built anywhere near today’s level of code, it still works just fine. Right? Well, while some building codes may be a tad excessive, often they use technologies that the electricians of the past would love to have had a chance to use. While it may come as an inconvenience, remind yourself that the technology available today can keep you and your family safe in a number of impressive ways. From safer walls and greatly decreased risk of house fire to GFCI outlets that will automatically detect an unsafe circuit and trip the breaker, killing the power and potentially saving a life.

Homes built after the 1940s were made with far safer wiring than any before that. Hopefully, by now, any home that predates that period would be completely re-wired with a new electrical panel for the longevity of the home, but this is wishful thinking. Today, millions of homes across the country and a good deal in Des Moines are essentially ticking time bombs, putting all of those inside at risk for electrocution or worse. While we don’t want to spread fear heedlessly, if you are considering the purchase of, or currently own, an older home, then you should get in touch with a licensed electrician to check the safety of your electrical system. Hopefully, everything will look and respond correctly, but there could easily be opportunities for improving the safety of your home.

In addition to the much older homes in the Des Moines area, newer homes are home to their own problems. If you ever notice an outlet begin to stop working unexpectedly, hear a buzzing in the wall, or even feel a current running, then you should make calling an electrician your top priority. Thousands of homes catch fire every year due to poor or faulty wiring, making this nothing to wait on, ignore, or even attempt to DIY; electricians should handle any blatant problems with your house wiring to keep your home safe. With homes popping up in and around Des Moines, our electricians have seen a surprising number of errors that could have been avoided by a more attentive installation, but that is a blog for another time.

If you suspect that your home’s wiring may be facing some issues, it really isn’t worth delaying to get in touch with the local electricians at Electrical Gurus. We have the tools and experience necessary to quickly determine what, if anything, the problem may be and then implement a fix that will keep your family safe. We understand how important it is to find affordable, trustworthy service for your household, which is why we take each call seriously and employ only the best local electricians.