Bryant Electric Service was recently inundated with calls the morning after a strong wind/thunderstorm blew through Austin.  This happens every time.  Although many calls were customers needing their power restored after tree limbs took down their overhead power line, there were also many calls wanting our service techs to come out to check their whole electrical system because of nearby lightning strikes damaging many of their home appliances and electronic devices.

With the enormous amount of electronics that are now being installed in almost every device that can be plugged into any power or phone/data outlet, it has become evident that having whole house power/data surge protection installed is imperative.

When lightning strikes it creates a huge static electrical field that, like the bolt itself, seeks the easiest path of least resistance to the ground.  The easiest path for this static current is your overhead electrical and phone/cable lines that run up and down your street and all of which connect directly to your house.  When this happens, it destroys the very delicate, low voltage instruments that are now installed in most appliances:  refrigerator, dishwasher, microwave, oven, coffee makers, washer/dryer, A/C and furnace, thermostat, garage door opener, sprinkler system control, etc.  These are all affected by power surges going throughout your electrical wiring system.  Then there are your TVs, computers, modem, hand-held charging devices, VCR, TV signal box, Bluetooth and your telephone, if you still have one, and these are all affected by the power surge through your phone/data cables.

If you are interested in receiving a cost estimate to have this protection installed in your house, please contact us at Bryant Electric Service and one of our dispatchers will be happy to help you.

Crystal chandeliers have come a long way from the days as traditional, stately pieces only enjoyed in the most formal of spaces and positioned to impress guests in the dining room or the foyer. Crystal’s are found in various lighting applications of all shapes and sizes and their sparkling, elegant affect is energizing areas of the home from powder room and office to kitchen and bath.

More crystal means more cleaning, but it does not have to be too taxing. A few simple guidelines will help to keep your crystal chandeliers looking their best.

How to clean it

If you do not wish to remove the crystal components from the piece, you can use a spray. After the piece is sprayed, wipe off the solution with white cotton gloves. Crystal chandelier manufacturer Schonbek recommends a solution of one part isopropyl alcohol to three parts distilled water, while Waterford’’s chief lighting designer Billy Canning says hot soapy water will do the trick. Both agree that special cleaning formulas aren’’t needed.

“A real no-no in the area of cleaning chandeliers: …If the chandelier is adorned with a traditional polished gold finish or polished silver finish but it i’s not stainless steel, people will use these sprays that you can buy,” says Eileen Schonbek Beer, Creative Director for Schonbek Worldwide Lighting. “Basically, what the manufacturers say is you spray the chandelier and let the stuff drip off, that cleans the crystal. But in fact what it does is ruin the frames of the chandelier.”

If more aggressive cleaning is needed, the crystal parts will need to be removed from the frame. The crystals can then be hand-washed in soapy water, rinsed clean and dried with a cloth. Schonbek provides trim diagrams that detail reassembly of the chandelier.

For dusting between cleanings, Schonbek recommends using a feather duster, lambswool duster or a make-up brush.

How often to clean it

In general, crystal should be cleaned every two to six months. The frequency of cleaning required depends on where it is used and how easy it is to get to the piece.  According to Canning, extremely large pieces like 20-foot chandeliers can get away with being cleaned only once a year.

Since crystal lighting is being featured in virtually every room of the house these days, some pieces may need more frequent cleanings based on their location. Chandeliers used in kitchens will need more detailed cleaning due to oil and grease buildup, as well as dust sticking to the components due to moisture from sinks and stoves.

“The beauty of crystal, of course, is the prismatic refraction of the light passing through the crystal ornament,” says Beer. “So the minute it’s got any kind of residue of dust or even moisture — like in moist climates in Florida — the humidity will cause dust to adhere to the crystal and the salt in the air will kind of make it cloudy. So you actually have to clean crystal pretty regularly.”

Maintaining a regular cleaning schedule for crystal will always keep it sparkling. Yet if a piece is neglected, all it takes is a little extra effort with the methods listed above to make it shine like new.

“In my personal experience, I have been asked by many auction houses to identify Waterford products many times,” says Canning. “In most cases the difficulty with identification would have been that the chandelier was allowed to get dirty and the crystal would appear dull. But in all cases, when properly cleaned, they can look as good as the day they were bought.”

For the Chore-Challenged

For customers who aren’t ready to get into the nitty gritty of cleaning their crystal by hand, suggest the Da Vinci chandelier from the Geometrix collection by Schonbek. The crystals stay attached to a stainless steel frame that can be placed directly in the dishwasher. The Da Vinci is available in a 10-inch or 36-inch diameter. The only Da Vinci that will not make it to the dishwasher is the dramatic 5-foot model.