We can always find ways to save a few extra dollars, but sometimes it can be little difficult to pinpoint exactly where those savings are to be had. You may look at the budget over and over and still keep coming up with the same bottom line. An electrician in Santa Monica can help you discover a few ways you could cut your electric bill without dramatically changing your lifestyle. If you ever have any questions or concerns about these tips, you can call The Electric Connection to ask more questions.

1-Get rid of any of those remaining incandescent light bulbs. They are costing you money. You can shave 20 percent off your electric bill simply by relying on CFL and LED bulbs that are much more energy efficient. They tend to be a bit brighter as well.

2-Have a ceiling fan installed in a central room of your house. This will help circulate hot and cold air produced by your furnace or air conditioner. Ceiling fans run on a fraction of the electricity of a heating or air conditioning unit. It is a good idea to have the fan installed by someone familiar with Santa Monica electrical codes.

3-Ask every member of the household to shave off 2 minutes from their average shower time. This can save a lot of money on your electric bill by reducing the demand put on the hot water heater. You could also turn down the thermostat of the water heater by about 5 to 10 degrees and save even more money.

4-Unplug any appliances, computers and electronics when they are not in use. When you leave for the day or go to bed at night, unplugging your electronics can save you money on wasted phantom power.

Give The Electric Connection a call today to have your ceiling fan installed or to learn more about energy savings.

We’ve added a new line of 

Using 316 marine-grade stainless steel and polycarbonate lenses, the 60-, 120-, and 180-watt LED boat lights resist damage from shock and vibration. Hardware is included for surface-mounting on a variety of transom types, and the LED lights must be completely submerged to function properly. To prevent failure due to out-of-water use, a built-in temperature protection circuit powers the lights off if they reach 194 degrees Fahrenheit. The underwater boat lights operate within a wide 9-32V DC range and are designed to last 50,000 hours.

As a California homeowner, you know that this is not the best time to put your house on the market, which may be why so many people are opting to upgrade their existing homes instead of seeking a replacement. One of the improvements you should consider is an electrical make over.

Electrical wiring can suffer wear and tear, and older homes were simply not built to meet today’s electrical needs, but these deficiencies can be overcome by hiring an experienced electrician. Santa Monica, CA building codes have changed over the years as well, and companies like The Electric Connection that specialize in rewiring older homes can bring your house into compliance with the latest regulations.

If your home was built during the 1960s and 1970s, you may be living in a fire trap. During that time approximately 2 million homes were built or remodeled using aluminum wiring before it was discovered that this type of wiring poses a significant fire hazard. The problem occurs at the electrical connection points where the wiring is spliced to connect to a switch, outlet or circuit breaker. Aluminum expands and shrinks in response to temperature changes, a process which can cause breaks and frays over time. The US Consumer Product and Safety Commission (CPSC) has expressed grave concern over this issue stating that homes with aluminum wiring are up to 50 times more likely to have a fire than homes with copper wiring.

How will you know if you need to have all of the electrical wiring in your house replaced? Fortunately, you may not necessary need a complete rewire in your home or business. A licensed electrician in Santa Monica can evaluate this for you, and tell you to what extent you’ll need to go in order to make your home safe. The Electric Connection, which specializes in house rewires explains that depending on the situation, there might be a fairly inexpensive solution. For example, you may simply need to replace the connection points in your home or business with copper electrical connectors. Not every Santa Monica electrician is trained in this type of retrofit, so you when you’re searching for electrician Santa Monica, it’s important to find a highly trained and fully licensed electrician to perform aluminum-to-copper retrofits.

Older homes, those built prior to 1950, may have a different electrical safety issue. During this time many homes used cloth insulated wiring, something which can appear similar to the insulated wiring used today. The danger builds over time; as the cloth ages it dries and can begin to flake off. Once portions of the wire are exposed, they pose a serious shock and fire danger.

Another challenge presented in older homes or buildings with cloth insulated wiring is that this wiring was frequently not grounded. At the time there were a limited number of electrical appliances and no home computers, so grounding was not considered a serious issue. Today all new homes are grounded so that excess electrical charges caused by electric surges are routed out of the house and into the ground, protecting electronic devices, computers and appliances. An electrician from Santa Monica can replace cloth insulated wiring with a grounded system, making your home and belongings safe from electrical fire and damage caused by power surges.

Another problem with older homes is the lack of three-prong outlets, something that is necessary for most modern appliances. Many homeowners mistakenly think they can simply purchase the three-prong version at the hardware store and swap out their existing two-prong outlets, but doing so can create additional fire risks. Properly swapping out these outlets requires some rewiring so that the three-prong version is grounded. Your Santa Monica electrician can do these quickly and inexpensively for you, and can make certain that any existing three-prong versions have been installed properly.

So how do you determine what type of electrical wiring is in your Santa Monica CA home? The first step is to check the build date. If your home was built before 1950, you can call the Electric Connection for a free electrical estimate by a licensed Santa Monica Electrician. They will be able to quickly evaluate any electrical safety issues that you might have in your home or business electrical system.

Flush or Semi Flush?

Flush mount and semi-flush mount lighting fixtures are integral components in lighting design, adding interest and depth while providing ambient illumination and decorative lighting effects to hallways, bedrooms and bathrooms.

The difference between a flush and semi-flush light fixture is that a flush fixture fits snugly to the ceiling, while a semi-flush fixture is suspended, leaving a small gap between the ceiling and fixture.  Opting for a flush or semi-flush light fixture is based upon taste and proportional considerations, but a few standard rules apply:

♦ Semi-flush—Somewhere in between the chandelier and standard ceiling fixture, the semi-flush fixture shines with distinction.  Taking up just the right amount of space with the power to attract desired attention, the latest semi-flush light fixtures provide superb illumination with artistic excellence.

♦  Semi-flush fixtures provide an added benefit: the small gap allows for double the illumination with indirect uplight rebounding off the ceiling and downlight emitted directly from the fixture.

♦  Flush fixtures—Most often employed in homes with standard 7-foot ceilings to provide general illumination for bedrooms, bathrooms, foyers and hallways.

Novel compositions and unique finishes are available at a variety of price points and are being featured from top lighting vendors around the world, making it easier than ever to find ceiling light fixtures in keeping with your budget and style requirements.

Corbett Lighting offers outstanding flush and semi-flush lighting designs:

-CQ33 “Cirque” Semi- Flush Fixture

-120-33 “Karma” Flushmount Fixture